Warum ist das , was ich im Edison abspiele immer lauter, als das was ich in den Step Sequenzer hab.
Ich hab geschaut das nix im Kanal liegt, die Limiter aus sind, ...
Auch wenn ich dem Clip dann noch 100% statt den 78, gebe ist er leiser. Das kann doch nich sein.
Normalisiert ist, alle möglichen einstellungen sind ausgeschaltet
So kann ich nix einschätzen. Kann man das irgendwie gleich stellen ?
wenn du ein sample in die playlist ziehst ist es auch lauter als wenn du es in den stepsequenzer ziehst.
es sind verschiedene einstellungen. teste mal obs immernoch lauter ist wenn das sample direkt in die playlist gezogen wurde.
Hier die Erklärung von FL-Studio:
Sampler Channels vs Audio Clips
If you are paying particularly close (and possibly unhealthy) attention to the output levels of Samples playing from Sampler Channels, you may notice they are a few dB down on their level when played as Audio Clips in the Playlist. There are three reasons for this:
1. Sampler Channels load at a default 55% volume, about -5.2 dB. This 'feature' is to prevent clipping when several Channel Samplers are used together and also to allow some extra headroom for note/step velocity modulation. The assumption is that Channel Samplers will be used as 'instruments' and so you will be playing (see the next point) and mixing them to sound right 'in the mix'. If a Channel Sampler is too quiet, turn it up.
2. Sampler Channels respond to note velocity. The default note velocity in FL Studio is 100 (MIDI = 0 to 127). If a sample is too quiet you can also play it louder.
3. Sampler Channels respond to the default Circular Panning Law. This reduces the sample gain by -3 dB at center pan, tapering to 0 dB at the extreme L/R pan positions.
So together the default load state for a Channel Sampler can be about 8.2 dB lower than the samples actual recorded level. If you absolutely need a sample to render at its recorded level, load it as an Audio Clip by dropping your samples on the Playlist (these default to 100% volume, 0 dB). Finally, make sure the Master and Main volumes (described above) are set to 0 dB and don't forget the effect of note velocity on playback level.
